alert Your browser is out of date. To download an updated version free-of-charge click here: UPDATE


Technical features

  • Power supply features
  • Power supply: 12 Vdc nominals; 11,5 Vdc min; 14 Vdc max
  • Voltages: +3,3 V; +5 V
  • Self-restorable fuse on electrical mains
  • Absorption in idle state (at 13,8 V): over PSTN line ≤55 mA; with GSM200 ≤85 mA
  • Absorption in alarm conversation mode (at 13,8 V): over PSTN line ≤105 mA; with GSM200 ≤200 mA
  • Data transmission and signalling system
  • Modem v.23 (PSTN line): 300-1200 bps FSK
  • Modem GSM (with GSM200): 9600 bps
  • Voice recorder: 4 minutes
  • DTMF dialing over external line
  • Tones generator: 659 Hz, 740 Hz
  • DTMF generator
  • External line tone recognition: 425 Hz
  • HANDSHAKE tone detector: 1400 Hz, 2300 Hz
  • Tele-programming protocol: proprietary
  • Elevator control protocol: proprietary
  • Service center protocol: Esse-ti, P100, Ademco Contact ID, CPC upon request and others
  • Telephone terminations
  • Connection to public telephone line
  • Connection to GSM line: by proprietary GSM200 gateway (plug RJ-45) or GSM500 gateways
  • Local telephone connection (plug RJ-11 / terminal block)
  • Built-in active handsfree terminal
  • Output for pit auxiliary active hansfree terminal
  • 2 passive handsfree terminals or cable with microphone connections
  • Microphones inputs: 2
  • Auxiliary loudspeaker output for connection to max 2 loudspeakers
  • Connections
  • Internal line - External telephone line
  • Internal line - Handsfree
  • External telephone line - Handsfree
  • Input/output
  • Double-contact emergency-call pushbutton with bell pictogram
  • Alarm send LED (yellow)
  • Alarm received LED (green)
  • Outputs: alarm given indicator light and alarm received indicator light
  • Alarm inputs: 2
  • Filter input
  • Led indicator for operation status
  • Led indicator for GSM200 signal strength
  • AL100 power supply input
  • Door-opener relay output (24V 1A)
  • Safety systems
  • EEPROM for data storage under power failure
  • Built-in NiCd battery for clock data storage
  • Double watchdog system
  • Firmware upgrade and settings download by Flashkey
  • Additional data
  • Dimensions: 140 x 80 x 25 (h) mm
  • Weight: 475 g

Main services

  • Emergency alarm call management and periodical test in compliance with EN81-28
  • Allows to manage up to 12 telephone numbers to be freely associated with different alarm types and receivers
  • 4 different types of alarm sending: vocal to a remote telephone or to a call center with manual-call management, to call center with Ademco, P100 or Esse-ti protocol , SMS (only with GSM200), CLI
  • 3 local programming modes: telephone, Flashkey, PC with HeControl software
  • 3 remote programming modes: telephone, PC with HeControl software, SMS (only with GSM200)
  • Technological alarms: low battery, no power supply (only with Esse-ti external power supply), diagnostic procedure, expiring SIM credit and expiring SIM card (by GSM200 gateway), serial line (via protocol)
  • Programming, surveillance, alarm and periodical test calls management by PC
  • Data transmission with connection to elevator CPU management to: send alarm from the elevator, broadcast messages in the car, elevator remote control
  • Remote management: data transmission with GSM200 (proprietary protocol) or GSM500 (via serial port in standard RS232, RS485 and CAN-bus)
  • Compatible with induction loop as per EN81-70
  • Clock management
  • Event's log with timestamp
  • Multi Sharing function: simultaneous notification of the same alarm to different receivers.
  • Digital volume adjustment
  • 60 customizable and pre-recorded voice messages
  • Excellent speech quality
  • Reduced cabling
  • Easy installation and programming
  • Quick firmware update 


Handsfree terminals

  • Cod. 6CV-30022  
See the product
Passive handsfree terminal
  • Cod. 5HV-002  
See the product
Passive handsfree terminal
with pushbutton
  • Cod. 5HV-004  
See the product
passive handsfree terminal
  • Cod. 5HV-006  
See the product
Passive handsfree terminal
pre-wired L= 3m
  • Cod. 5HV-021  
See the product
Passive handsfree terminal
pre-wired L= 6 m
  • Cod. 5HV-025  
See the product
Active handsfree terminal
  • Cod. 5HV-001  
See the product
Active handsfree terminal
with pushbutton
  • Cod. 5HV-003  
See the product
active handsfree terminal
  • Cod. 5HV-005  
See the product
handsfree terminal
  • Cod. 5HV-010  
See the product
Hardware and Software design
and development carried out
at the Esse-ti Research Center.
100% made in Italy.
  • Compliant
  • EN 81-80
  • EN 81-28
  • EN 81-70