Remotable 4G LTE satelliteHelpyGSM-RM S, equipped with the remotable 4G RMsatellite, is the solution for the utmost flexibility.
The autodialler can be installed on the elevator car-top, in the lift shaft, in the machine room or on the elevator controllers, and, thanks also to the prewired cables, the installation has never been so easy.
The autodialler comes with:
- remotable 4G rm unit,
- GSM connection cable L=1 m ,
- speaker unit,
- power supply and back up battery,
- alarm and reset pushbuttons,
- 230V power supply cable,
- LEDs signalling operation status, GSM signal strenght, line status and power supply status.
The 4G RM satellite for local or remote installation is made up by an industrial LTE module, magnet base, whit antenna and connection cable L=1 m. The SIM Card must be insert in the GSM satellite and it can be placed where the signal is better.
- Emergency alarm call management and periodical test in compliance with EN81-28
- Up to 12 programmable telephone numbers
- Supports up to 6 add-on handsfree terminals
- Digital volume adjustment
- Advanced self-diagnosis system
- Local and remote programming by analog telephone, SMS, PC with e-stant software
- Programming, supervision, alarm management, test calls from PC
- Alarm sending modes: voice, SMS, CLI, esse-ti protocol, P100
- Multilanguage manu with 5 options, customizable with e-stant software
- Alarms ending with or without entry codes
- Activation of communication with the cabin without entry codes
- Multi-function programmable relay
- Multi-Sharing function: simultaneous notification of the same alarm to different receivers
5KT-023
Pre-wired kit
The wiring loom allows to comply with the EN 81-28 regulations and saving on cabling costs.
Suitable for the autodiallers installed on the lift car top, allows a quick and secure installation.
Inclusive of:
- shielded cable with microphone for the elevator car,
- pre-cabled yellow and geen LEDs,
- free wires for connection with the existing emergency-call pushbutton,
- speaking unit with pushbutton for the car bottom.
By connecting the terminal block to the compatible autodialler, it allows the installation of the microphone behind the car cabin, the pre-wired yellow/green LEDs in the cabin, the free wires for connection of the existing pushbutton, and the speaker unit with alarm pushbutton in the car-bottom.
5HV-036
Passive SLIM speaker unit
Additional speaker unit to be connected to an active speaker unit, to a 2-wire speaker unit or to an Esse-ti autodialer with specific output for additional microphone and loudspeaker.
The passive SLIM speaker unit is designed for installation behind the COP.
The speaker units allow two-way communication with excellent audio quality and low consumptions.
Equipped with advanced self-diagnosis system to detect cabling errors or damages, they guarantee the utmost reliability.
Quick and easy to install, offer the possibility of combining active and passive handsfree terminals to save on installation costs.
The telephone-technology speaker units offer a comprehensive choice in terms of casing. The wide range of size and fittings combines functionality and versatility in order to meet any installation requirement.
5HV-021
Pre-wired passive speaker unit
The pre-wired speaker unit with pushbutton and shielded cable L= 3m, allows the easy and quick installation on the elevator car-top or in the pit.
The passive speaker unit with pushbutton must be connected to an active or 2W speaker unit for additional microphone and loudspeaker,or it can be directly connected to Esse-ti autodialers with specific output.
The speaker units allow two-way communication with excellent audio quality and low consumptions.
Equipped with advanced self-diagnosis system to detect cabling errors or damages, they guarantee the utmost reliability.
Quick and easy to install, offer the possibility of combining active and passive handsfree terminals to save on installation costs.
The telephone-technology speaker units offer a comprehensive choice in terms of casing. The wide range of size and fittings combines functionality and versatility in order to meet any installation requirement.
5HV-103
Passive stainless-steel speaker unit
The stainless-steel panel with passive handsfree terminal comes with:
- alarm pushbutton,
- Leds signalling alarm sent / alarm received,
- pictograms.
Designed for wall-mounting installation inside the elevator cabin or at the floors.
This speaker unit to be connected to an active or 2-Wire speaker unit o for additional microphone and loudspeaker.
It can also be directly connected to Esse-ti autodialers with specific output: Helpy Compact, Helpy Compact-V, Helpy Compact-TL, Helpy GSM, Helpy GSM-RM.
The handsfree terminals allows two-way communication with excellent audio quality and low consumptions.
The telephone-technology handsfree terminals offer a comprehensive chioce in terms of casing. The wide range of size and fittings combines functionality and versatility in order to meet any installation requirement.
5HV-170/1
Induction loop
The induction loop is a hearing aid specifically conceived to enable two‐way communication for hearing‐impaired elevator passengers.
Thanks to the induction loop, in the event of an emergency call, a hearing‐aid wearer is able to listen clearly to the voice prompts broadcasted by the emergency phone and can communicate perfectly with the service center operator without any background noise or interferences.
The induction loop may be connected either with Esse‐ti handsfree terminals or with any branded auto dialer/device equipped with a specific audio output.
Equipped with backlit pictogram and microphone, provides an excellent audio quality.
SLIM analog telephone – with handset keypad
SLIM telephone set to be mounted in the machine room to ensure programming, local reset of alarms and direct communication with the lift car and the handsfree terminals.
ST100L analog telephone
Analog telephone with DISPLAY. To be mounted in the machine room to ensure programming, local reset of alarms and direct communication with the lift car and the handsfree terminals.
Private: Vivavoce attivabile con pulsante
Terminale di tipo telefonico specifico per la comunicazione con la cabina. Ideale per l’installazione all’interno di quadri MRL in sostituzione della cornetta telefonica.
Antenna extension cable
L= 15 m
