HGSM FS B2ba4320041661a049d5b26717d9bf07

HelpyGSM can be installed on the elevator car-top, in the lift shaft, in the machine room or on the elevator controllers: the flexible and compact solution, that makes installation easier and quicker also thanks to the prewired cables.

The autodialler comes with built-in GSM module, handsfree terminal, power supply and back up battery, magnet-base antenna with cable L=2 m, alarm and reset pushbuttons, 230V power supply cable, LEDs signalling operation status, GSM signal strenght, line status and power supply status.

Helpygsm Details

Max Handsfree6


  • Emergency alarm call management and periodical test in compliance with EN81-28
  • Up to 12 programmable telephone numbers 
  • Supports up to 6 add-on handsfree terminals
  • Digital volume adjustment
  • Advanced self-diagnosis system
  • Local and remote programming by analog telephone, SMS, PC with e-stant software
  • Programming, supervision, alarm management, test calls from PC
  • Alarm sending modes: voice, SMS, CLI, esse-ti protocol, P100
  • Multilanguage manu with 5 options, customizable with e-stant software
  • Alarms ending with or without entry codes
  • Activation of communication with the cabin without entry codes
  • Multi-function programmable relay
  • Multi-Sharing function: simultaneous notification of the same alarm to different receivers
Hardware and Software design and development carried out at the Esse-ti Research Center. 100% made in Italy.

Compliant: EN 81-80, EN 81-28, EN 81-70


Power supply features
Power supply required: 16 W
Mains voltage: 230 Vac +5% -10%
Self-restorable fuse on electrical mains
Built-in back up battery: NiMH 7,5V 800 mA
Expected operation time with a new battery in idle state: 20 h
Expected operation time with a new battery in conversation with remote handsfree terminal: 4 h
Expected operation time with a new battery in conversation with built-in handsfree terminal: 5 h
Input: 12Vdc 500mA
Service center protocols: P100, esse-ti
Other protocols upon request
Voice messages
Available languages: 5
Pre-recorded voice messages: 30 minutes, restorable
Messages that support the programming
Alarm messages
Elevator identification message: customizable (max. 1 m)
Courtesy message for the car: customizable (max. 1 m)
Messages customization: via computer (via serial port and software e-stant
Mobile network
GSM network connection: built in
Module: GSM/GPRS quad-band
Transmission power: 1 W at 1800/1900 MHz, 2 W at 850/900 MHz
Type of dialling over external line: DTMF
Local telephone connection: plug RJ-11 / terminal block
Built-in active handsfree terminal
Outputs for auxiliary active hansfree terminals: 2
Auxiliary microphones inputs: 2
Auxiliary loudspeaker outputs: 1 (to connect max. 2 passive handsfree terminals or loudspeakers)
Internal line - External telephone line
Internal line - Handsfree terminal
External telephone line - Handsfree terminal
LED signalling alarm / periodical test call: yellow
LED signalling GSM signal strength: green
LED signalling GSM status: red
LED signalling power supply status: blue
Built-in reset pushbutton : 1
Built-in emergency-call pushbutton:1
Alarm inputs: 2
Customizable inputs (emergency alarm or auxiliary input): 1
Filter inputs: 1
Outputs (alarm given/alarm received): 4 (NPN/PNP)
Programmable relay output: 1 (max. 250 Vac o 220 Vdc)
Safety systems
FLASH memory for data protection under power failure
Built-in battery for clock back-up: NiCd
Double watchdog system
GSM reset
Firmware update
Remote: OTA (via GPRS)
Local: via computer (via serial port and software e-stant
Additional data
Antenna: magnet-base cable with antenna (2 m)
Dimensions: 60 x 165 x 125 (h) mm
Weight: 655 g



Valore non valido
reCAPTCHA not valid
Web Marketing e Siti Internet Omnigraf Pos Col